Go to our Facebook page
Once you find the question that you're looking for, simply click the question and your answer will appear directly below it. Once you're finished with that question, click it again and the answer will disappear.
Why is air control equipment necessary?
What causes excessive pressure drop on the main line gauge of the filter/regulator?
Do I have to flush my sprayer at the end of the day?
How often should I tighten the packing nut on my airless sprayer?
I maintain my sprayers with my own mixture of spirits, solvents and mild cleaning solutions. Is there any material I should avoid using for this process?
My user's manual says that I don't have to clean the unit when you take breaks while painting. I want to know if it is okay to leave the sprayer loaded overnight? If I plan on spraying with the same paint the next day do I have to clean the unit, store it and then load it up again the next day?
I have flow, but how do I know if my fluid regulator is working?
What are the advantages of using electrostatic equipment over conventional spray equipment?
How do I prepare the paint?
I need a part sheet, service bulletin or operator manual.
My spray gun is spraying heavy to one side of pattern.
My Siphon/Suction spray gun is spitting, sputtering or blowing bubbles in the cup.
I am experiencing orange peel in my finish – my finish is irregular and bumpy with craters.
What is the difference between Conventional, HVLP, Turbine HVLP and Trans-Tech (LVMP) technologies?
What fluid tip, needle and air cap would I use to spray a particular product?
What horsepower compressor will I need to operate my spray gun and tank or pump?
Why am I getting a meager flow from my tip?
What are the advantages of "triggering" a spray gun?
What criteria should be known when selecting a Spray Gun?
Why do I get streaks in my spray pattern?
How do I know what size needle and nozzle is best for my application?
Why is my gun spitting a small paint stream of paint after I release the trigger?
Why did my airless gun stop spraying?
Where can I find out more information regarding spray gun fundamentals, material application, finish problems, and the latest information regarding spray gun technology?
How does tip wear affect my spraying?
How does tip wear affect my setup?
How can I make my tips last longer? What causes tip wear?
How should the air cap be cleaned?
What causes the spray pattern of my airless gun to feather?
What causes a top or bottom-heavy spray pattern?
What parts of the spray gun require lubrication?
I cannot trigger my spray gun. What causes this problem?
How do I choose an airless tip?
How do I back flush the fluid hose to my pressure pot and why should I do this?
How do I care for heated hoses?
Can I mount the electrostatic air hose to a reel mounted on a trolley cart which is grounded? Do I need a grounding wire at the gun to prevent paint from coming back to the painter holding the gun?
What is the life expectancy of my hose?
How long should a gun last before needing to be rebuilt? What can I do to make it last longer?